Horserail - Introducing Safe-T-Brace Cable

1. End Post Assembly

Place the loop end of the brace cable around the end post from the wire or rail side of the fence.
Position the loop near the inside, center line of the post. Orient the loop for ease of lacing. Staple cable to post 6˝ (15 cm) up from the ground line and within 4˝ (10 cm) from the loop.
Lace the other end of the brace cable through the loop as though you are lassoing the end post, pull the brace cable all the way through loop until
taut - then manually bend the cable at the loop end to hold in place.

Kit Includes:

• Four 16' (488 cm) Twisted Strand High Tensile Brace Wire (for 10´ (304 cm) Top Horizontal Brace)

• One Mini Spooler: (with locking pins)

• Three 1.5˝ (38mm) Staples

Click here to download our Flyer in PDF format.

For more information or to order please contact:
info@safe-t-brace.com

2. Added Safety Pipe (Optional)

Slide on an 8.5´ (260 cm) to 9´ (274 cm) long piece of 3/4˝(19 mm) min. OD electric conduit or rigid PVC, painted to match your fence.

3. Brace Post Assembly

Slide on the Mini Spooler.
Hammer a staple on both sides of the brace post under where the rail bracket or wire will be positioned.
Slide the cable end through one staple and back around the brace post through the other staple.

Position the Mini Spooler about 8˝ (20 cm) from the brace post. This will leave about a 6˝ (15 cm) to 8˝ (20 cm) loop of cable brace out from the brace post. (see drawing)
Slide the cable end through and beyond the remaining center hub hole about 1˝ (25 mm).
Hammer the staples snug but NOT overly tight.

4. Tensioning Mini Spooler

Place both ratchets into the Mini Spooler hubs. (top and bottom)
Slide the Horserail® 2˝ (5 cm) Extended Handle onto the ratchets.*

Pull the Handle (don’t push) to tension the cable. With your hand - carefully hold the Mini Spooler to stop it from unwinding. Ratchet back the Handle, release the Mini Spooler and pull again, then hold the Mini Spooler, repeat
this process until taut.
Lean into the Handle with your body while inserting both locking pins - locate pins in opposite holes - closest to the cable brace.

* Note: The above tensioning techniques are for a one man installation using a Horserail® 2˝ (5 cm) Extended Ratchet Handle. In a two man installation, one man could use two 24˝ (60 cm) Long Handled Ratchets while the other man sets the locking pins.